HOW TO WIRE 2 FIRE ALARM PULL STATIONS TO 3 STROBES

In this video I wired my Grinnell RMS t1 aka T-bar pull station and my BG 12 pull station to 3 strobes my spec alert my system sensor and my Wheelock strobe with a 9 vol adapter and it basically is like the fire alarm panel were u pull more stations and they go off now if u connected positive to positive and nagtive to nagitve u only can use one pull station if u know how to wire you can use 2 pull stations just follow this 1 9 vol adapter split the line make nagtive and positive off the positive make lines witch are positive then take 1 line off the positive to the positive of ur main pull station then take the other one and put to the positive off the other then off the main pull station positive run one line up to the positive on 1 strobe then another line from the same pull stations positive to anther strobes positive then off the 3 strobe take the positive line on it and run it to both nagitves on the pull stations then take the nagitve from the other two strobes and run to nagitve of ac adapter and boom u did it good luck and im not responsible if u mess up its a lot of thinking go slow and think NOTE! This is for educational/entertainment purposes ONLY! THIS IS NOT A SUBSTITUTE FOR A PROFESSIONALLY INSTALLED LIFE SAFETY DEVICE! IF YOU DECIDE TO DO WHAT I SHOW IN THIS VIDEO, YOU DO SO AT YOUR OWN RISK! I ASSUME NO LIABILITY!