Trailer Wiring Connector Installation - 2007 Lexus RX350 - etrailer.com

http://www.etrailer.com/tv-wiring-install-2007-lexus-RX350.aspx Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information. Today on this 2007 Lexus RX350 we are going to be installing the 4-pole harness part number 18002. The Lexus that we are going to show you today has a unique situation to it. On our website we indicate the wiring for the Lexus is going to be the modulite part number 119176. This particular Lexus does have a factory installed tow package that we are going to be able to tap into so we are going to show you how to locate that. The port is located in the rear cargo area of the vehicle underneath the flooring over on the driver side. We are going to need to remove most of this interior section. There is a particular order of operations that we need to abide by to get all of the components out. 00:38 We are going to start by removing the forward most cargo door. We need to pull back the facing at the front section first. There are push rivets that are holding that in place so just pull it up. We need to unscrew the hinges that are holding the flooring into place. There is one screw per side for these hinges. We next remove the forward most cargo storage area. There are two push rivets holding this into position. One on the driver side and one on the passenger side. We are going to be using a rivet removal tool. We need to slide it underneath and just pry it up. 01:11 Next we are going to remove the front storage compartment. To access it we need to release the two coverings and there are buttons at the rear threshold to do that. Again, we have got two push rivets holding it in place. One on the driver side and one on the passenger side. Next we will remove the driver side floor covering and there are actually four bolts holding it into position, two here at the rear side and two at the forward side. Next we will remove the rear threshold piece. There are two push pins that are holding this into position. One on the driver and one on the passenger side. When removing the threshold piece you need to watch the releases for the cargo buttons. Make sure you clear the releases for the cargo doors. When you get the threshold piece to release you need to press these in. Finally we want to remove the driver side storage compartment. We have got two fasteners holding it in position. One push pin here and one here at the inside of the cargo area. 02:22